Mould Design Two

Design two takes four moulds and places them over the cheekbone and the supraorbital ridge. The moulds are coloured to the skin tone. There will be no other colour on the face. The products needed for design two are as follows: 

- Moulds

- Prosaide

- Prosaide Remover

- Dermashield

- Illamasqua Matte Primer

- Kryolan Ultra Foundation 

- Kryolan Dermacolour Camoflague Concealer

- Vichy Setting Powder

- Student colour palette

- Alcohol 

- Acetone

Cleanse, tone and moisturise the skin. 

Apply Dermashield to protect the skin from the products.

Use Illamasqua matte primer all over the face.

Apply prosaide to the face in order to stick the mould to the face. Make sure the client has their eyes closed at all times.

Attach the mould by sticking the edges to a card, apply the centre of the mould onto the prosaide.

With acetone and a baby bud gently blend out the edge of the mould. The card will remove at this point. 

Blend the edges thoroughly so that it is invisible.

Using foundation and the student colour palette try and get the same skin tone as your client. The student palette is activated by alcohol so it is important that your client closes there eyes at all times.

Powder to set.